ToolsforHealing.com

Key Design Features and Functions

Frequencies of 4Hz, 16Hz and 100Hz that are selectable for use as a Beck Pulser with built-in digital timers. Set the timer with the push of a button (30 minute increments) and the unit will beep indicating the session is finished.

Frequencies of 2128Hz, 10kHz and 30kHz that are selectable with a pre-programmed zapper sequence for use as a Clark Zapper.

Built-in digital timers (10 minute increments) are also used in Colloidal Silver DC Generation.

Built-in digital timers (30 minute increments) are available for experimenting with Colloidal Silver AC Generation.

0 to 9 Volt DC Pulses (may be used for research as Dr. Clark's Zapper)

Continuous zapping mode.

0 to 30 Volt DC (may be used for Colloidal Silver DC generation)

Multiple ways of producing Colloidal Silver Mode with current limited to ~15mA with timer (10 minute increments)

Mode with adjustable current limited from ~0.5mA to ~30mA with timer (10 minute increments) - (external silver rod assembly not included)

Mode with Automatic Polarity switching every 2.5 minutes (reduce buildup) with timer (10 minute increments) - needs an external silver rod assembly (not included)

-30 to +30 Volts AC Pulses (may be used for researching Dr. Beck's Pulser protocol)

Modes with adjustable intensities of ~0.5mA to ~30mA with selectable frequencies of 4Hz, 16Hz and 100Hz

Other Special Modes available

Modes for researching Colloidal Silver AC generation at higher frequencies with timers

Modes for researching Colloidal Silver generation using pulsed DC with timers

Modes with pulsed DC